Sim'n Tonic Forums

Hello!

Running into a little hiccup. All my drivers are updated and running Abelton 11.3.43 . I’ve followed all the correct instructions and even did some adjustments to see what worked and didn’t. After following all the directions I noticed that when shifting the fader ms on U-Sync, not much was happening. After viewing tutorials I still can’t get it to line up on the grid.

I have to move my driver error compensation around for it to land on the grid and I’ve landed on these settings. I still feel like some is wrong here and doesn’t seem as seamless as others are saying.

Anyone having this issue or know what can be going on here?

Hi

Thanks for asking here. Yes this is definitely not expected, and you should set the Driver Error Compensation back to zero.

The U-SYNC slider not affecting the recordings' timing is a quite common error. It could be caused by:

• Wrong monitoring settings in Ableton
• No Delay Compensation turned on
• What you are recording is not using the MIDI Clock from the Nome

Could you please check these? See also the U-SYNC Quick Start PDF section 2.3 in particular (but feel free to check the whoel section 2 as something else might be missing there).

Simon