Nome 2 not syncing with Abelton 11.

[KMRT]

Hello!

Running into a little hiccup. All my drivers are updated and running Abelton 11.3.43 . I’ve followed all the correct instructions and even did some adjustments to see what worked and didn’t. After following all the directions I noticed that when shifting the fader ms on U-Sync, not much was happening. After viewing tutorials I still can’t get it to line up on the grid.

I have to move my driver error compensation around for it to land on the grid and I’ve landed on these settings. I still feel like some is wrong here and doesn’t seem as seamless as others are saying.

Anyone having this issue or know what can be going on here?

[simntonic]

Hi

Thanks for asking here. Yes this is definitely not expected, and you should set the Driver Error Compensation back to zero.

The U-SYNC slider not affecting the recordings' timing is a quite common error. It could be caused by:

• Wrong monitoring settings in Ableton
• No Delay Compensation turned on
• What you are recording is not using the MIDI Clock from the Nome

Could you please check these? See also the U-SYNC Quick Start PDF section 2.3 in particular (but feel free to check the whoel section 2 as something else might be missing there).

Simon