Hi,
i saw in the Manual that ther is a chance to use Din Sync 24. Does someone know if there is a ready soldered Cable on the market ? It´s no problem to solder one myself but if there is a ready solution its also ok.
Does any one have here some experience with Roland machines on the Nome2 ?
Using Roland TB 303 and Sync Cable
-
Simon
- Posts: 1205
- Joined: 09 Jan 2022, 22:08
Re: Using Roland TB 303 and Sync Cable
Hi Cit - yes plenty people are using this, it works trust me 
Regarding the cable you can solder one yourself, if so please make sure you follow the pins written on the DIN Sync wikipedia page (tip=clock, ring=start/stop).
There are indeed not a lot of commercial DIN Sync cable adapters out there, the most used one is the one from OXI I think: https://www.thomann.co.uk/oxi_instrumen ... daptor.htm
They are a few others on eBay/amazon but I would double-check before buying those.
Simon
Regarding the cable you can solder one yourself, if so please make sure you follow the pins written on the DIN Sync wikipedia page (tip=clock, ring=start/stop).
There are indeed not a lot of commercial DIN Sync cable adapters out there, the most used one is the one from OXI I think: https://www.thomann.co.uk/oxi_instrumen ... daptor.htm
They are a few others on eBay/amazon but I would double-check before buying those.
Simon