U-SYNC get confused when connecting multiple Nomes

[Simon]

Status: this will be solved in a future release (probably FW 4.1?) and the plan is to also allow the sync between multiple Nomes even when U-SYNC is used.
This way you can sync multiple Nomes by doing:

Code: Select all

DAW -> U-SYNC -> USB cable -> Nome #1 -> audio cable -> Nome #2 + #3 + #4 etc.

----

When connecting multiple Nomes (I or II) to your computer, the U-SYNC daemon gets confused and tends to lose connection. It works, but it might require restarting/replugging things every time a new device is connected or disconnected.

Expected Behavior: the Daemon should stick to the first device connected and not be affected by any other devices connected/disconnected until this first device is disconnected

Actual Behavior: when connecting a new device, it jumps from one device to another, and sometimes loses the connection to both devices

Nome generation (I or II) and Firmware version: both generations, FW 4.0.