Sim'n Tonic Forums

Short description of the issue:
When setting the Input mode, I scroll past pedal to pad, then the device freezes on the word "Pad". A power cycle is the only thing that will re-enable the buttons.

Setup (devices connected and how):
USB into a hub and then into Ableton.

Steps to Reproduce:
1. Press setup button on device
2. Scroll to inP
3. Push scroll knob to select
4. ped is displayed on the screen
5. Scroll right and "Pad" is displayed on the screen
6. The device is now frozen and will not accept any input.

Expected Behavior:
To be able to scroll right further and select 24p.

Actual Behavior:
Device freezes.

Nome generation (I or II) and Firmware version:
Nome I, FW 5.2

More info:
I might have accidentally run phantom power into the unit but I'm not sure.

Hi

Thank you for reporting!
Are you saying the device is completely unresponsive after you select "Pad" - pressing any of the button (in particular the settings button) has no effect?

Simon

Hi Simon, yes correct, I have to power cycle to get any buttons working again.

Mmm - this sounds like it could be a hardware issue with your device.
Can you try with:

• device is powered from a phone charger (not connected to a computer)
• nothing connected to the device
• change the setting to "PAd" again

Simon

Weird it works fine with a phone charger. I’m getting a new USB hub, I’ll see if that fixes it on the computer. Thanks for the support.