Sim'n Tonic Forums

It would be great if Nome II would have build-in speaker to produce audio click.
Thanks.

Great suggestion!! Thank you for creating the topic

Anyone else interested?

Simon

Not my choice of needed features, but I could see it being useful in some situations, especially if it's not hard to implement, and if it doesn't bring the cost up too much. Maybe an add on module in the future as an option?

Interesting!
Based on the community interest, this would never be an integral part of the device. It would be a simple attachable small speaker, purchased separately. The speaker will probably have a magnet and a plug to go into the "AUDIO" output

Simon

Simon wrote: ↑13 Nov 2024, 09:47 Interesting!
Based on the community interest, this would never be an integral part of the device. It would be a simple attachable small speaker, purchased separately. The speaker will probably have a magnet and a plug to go into the "AUDIO" output

Simon

That's what I had in mind. Basically, any small/low power speaker can be used (the attachable one is more convenient for sure), but does AUDIO output have enough juice for that?

Yes there is enough juice, and the output impedance is low enough as well - you can try it if you have a speaker at hand
I think the point is more the acoustics, trying to use the device case as a resonator for the sound so it amplifies it naturally

Simon

Maybe, setting the master volume for audio click would be super handy, because currently Nome II have two settings for volume: Vo.1 for first beat and Vo.2 for other beats.

It sounds like you could go through the manual a bit more
You can hold down the setup button and turn the knob to change both volumes at the same time

I apologize. I missed it. Thanks.