Sim'n Tonic Forums

I've seen similar posts about this topic, but wasn't able to figure anything out based on them.

I'm quite new to modular synths, having just got a Moog Mavis for Christmas. After a little time messing with it, I thought about the possibility of syncing the LFO Rate to the Midronome's BPM. Not sure where the best place to start is though, if there are any technical details I need to know about this particular synth, and what settings/outputs to use on the Midronome.

If there is a way to do this, I would be very happy to know! Thank you!

Hi

Well without look into details, there seem to be an input called "LFO Rate"?

So you could try
1) configuring the Midronome to send a 1ppq pulse: An.L setting to On (or PLA) and An.1 to 1
2) plug a cable from the ANLG output on the Midronome to the LFO Rate input on the Mavis

See if that works

Simon