Page 1 of 1
Can't sync my DAW
Posted: 02 May 2023, 21:27
by jswilliams
Hi, I've generated a sync file and have it outputting from Logic directly into the input of the Midronome. Normally, from what I gather, I'm supposed to see lights: either green or red, to adjust the input level with the SYn on? No lights come on and It won't sync. Any help here would be greatly appreciated.
Thanks
J-S
Re: Can't sync my DAW
Posted: 02 May 2023, 22:21
by Dave
jswilliams wrote: ↑02 May 2023, 21:27
Hi, I've generated a sync file and have it outputting from Logic directly into the input of the Midronome. Normally, from what I gather, I'm supposed to see lights: either green or red, to adjust the input level with the SYn on? No lights come on and It won't sync. Any help here would be greatly appreciated.
Thanks
J-S
Don't know Logic and don't yet have a Midronome, but that's probably an audio interface mixer and/or volume output issue based on my use of a USAMO.
Re: Can't sync my DAW
Posted: 03 May 2023, 08:30
by Simon
Dave is correct, it could be you are not sending the sync track where you think it is going. It could also be you are not in the settings (the display should be showing "Syn" - that's when you can check the LED's).
Have you followed the steps in the manual?
Re: Can't sync my DAW
Posted: 03 May 2023, 16:56
by jswilliams
I figured it out.. I inverted the sync track wav file so it outputs on the correct side. I have a cheap DB25 cable and it was outputting on the wrong side.
Thanks!!
J-S